Notre site Internet utilise des cookies pour garantir que nous vous donnons la meilleure expérience d'utilisateur. En continuant de parcourir notre site, vous êtes d'accord avec l'utilisation de cookie. plus d'infos
Following ASTM D1238, Instron's CEAST MF50 tester with a piston holding device can be used to test high fluidity of molten thermoplastics.
A CEAST Capillary Rheometer has been used to test the flow behavior of plastic cap liners of bottle cap to prevent leaks with a tight mold and quality seal.
A capillary rheometer, like the CEAST SR20, can find the flow characteristics of compounded thermoplastic elastomers used in the production of tires.
ISO 1133 and ASTM D1238 specifies testing methods for calculating the fluidity of plastics, and the CEAST Modular Melt Flow Tester follows Procedure B in ISO 1133.
Melt Flow Testers with load cells increase repeatability of testing Melt Flow Rate and Melt Volume Flow Rate in accordance with ISO 1133-2 and ASTM D1238.
Testing with CEAST Capillary Rheometers and Visual RHEO Software allows manufacturers to understand the change in polymer viscosity related to time.
ISO 11443 and ASTM D3835 are specifications for determining the flow properties of polymeric materials at temperatures lower and higher than the melting point.
With a CEAST SR50 Capillary Rheometer, Instron was able to test silicone materials to determine which can undergo extrusion at room temperature, observing ISO 11443.
Low viscosity fluid with a high-shear environment for spray application can be tested with an Instron CEAST SR20 capillary rheometer.
A controller can test how much a mold will shrink by placing it in a high-pressure chamber with controlled temperature, volume, and pressure, following ISO 17744.
For ISO 22007, testing technicians can determine thermal conductivity data easily by using Capillary Rheometers with applicable accessory.
Instead of manual cleaning methods, the Integrated Barrel Cleaning Device is used to easily clean Melt Flow Testers after every test to ensure accuracy.